Dear Jane:
Thanks for your concern.
Cut out a few frames
Suppose you want to cut out the movie part from frame(x) to frame(y). Then the
result movie will be starting from some frame(a) to frame(x), then frame(y) to the end frame(b). Where the part from x to y is cutted out now.
Below is what you should do:
1.select frame(a) as 'new start point', frame(x) as 'new end point', press 'add list'. So the
first segment is put into the
list.
2.select frame(y) as 'new start point', frame(b) as 'new end point', press 'add list'. So the
second segment is put into the list.
3.lighten up the button 'link'
4.press button 'Record List'. You will be asked for a new file name. After that, the transcoding will begin.
If what you want is to capture several frames into pictures, please use the 'capture frame' button.
Add a few frames to a file
Smart Cutter can link
movie files together.
Suppose you want to insert a small movie into a big one.
Below is what you should do:
1.Put first part of the big movie into list
2.Put the small movie file into list
3.Put the second part of the big movie into list
4.lighten up the button 'link'
5.press button 'Record List'
Please be
noticed: the inserted movie should have same parameters(such as video width height, frame rate, etc.) as the movie that it will be inserted into.
If what you want is to imprint several pictures into a movie, you must convert the pictures into movie first.
Best Regards,
FameRing Support Team