World's first frame accurate H.264 AVCHD cutter without re-encoding!

I have 2 video files, one high resolution(video01.mp4), another low resolution(video01.lrv)(it's mp4 format)
these 2 video are the same content(just different resolution)

I use the low resolution video(rename low resolution video to video01.mp4) save the cut points to the batch file(.bth).
Then close the smart cutter and rename it back( now video01 is high resolution)
and launch smart cutter again, then load the batch file, and all cut point seems fine,
but when I click start batch button, and then the smart cutter crash....

so, could you fix this issue? or just cant do this way?

Smart cutter 1.9.4
windows 10

Dear alex867:
Thanks for your message.

'just cant do this way?'
No, you can not do this in Smart Cutter.
Every time Smart Cutter loads a project/batch, it will read in file name and check the file integrity, if the file size changed, it will fail.

Please feel free to send us your further advice and suggestion.
Thank you very much.

Best Regards,
FameRing Support Team