World's first frame accurate H.264 AVCHD cutter without re-encoding!

No change at all with v1.9.3 on Windows 64: Still crashing in exactly the same spot as before.

There goes another year and a half. Will it take this long before the next attempt will be released? :-(

Hi vger,

In case any of this has a bearing on your problem...

Check out my last post on this topic under movieshop framer forum: http://www.fame-ring.com/forum/viewtopic.php?f=4&t=7392

I refer to SmartCutter crashing when editing my movies (setting start and end points) and the fix was to increase the number of IFrames present in file.

Also, I had earlier troubles where SmartCutter would crash immediately on opening some of my files, and it mis-identified the resolution (in movieshop framer it would not crash but would not give me any video). The problem there was my file was not recorded right (incoming was 'yuv 4:2:0' but I encoded it 'yuv 4:2:2') - read whole thread to see details. ffmpeg may help you work around the problems?

Regards,
Bryce Stenberg.

No, I'm afraid that's not the case here. These crashes happen while transcoding, about 5% into the file.

Regards