Smart Cutter 1.3.4 - many bugs
Posted: Wed Jan 05, 2011 3:41 pm
Bugs in Smart Cutter 1.3.4 portable, tested under Windows 7 64 Bit
1. At the cut position artefacts are produced (as described by Ralle http://www.fame-ring.com/forum/viewtopi ... t=157#p685).
2. If conversion is stopped ("Exit" in window "Please wait for message: conversion done!"), the program crashes: Error message of Microsoft Virtual C++ Runtime Library.
3. If a file shall be overwritten ("Record List!" and "link" activated), a new file is produced. If e.g. the file to be overwritten is called "Test.ts", then the new file reads "test.ts.12.ts". If "Test.ts" shall be overwritten further times, then the new additional files read "Test.0.ts", "Test.1.ts", etc.. The file "Test.ts" is never overwritten.
4. If the order of the batch list is changed by drag and drop, only the lines are moved in the list on the screen. However, "view" shows that the order of the internal list hasn't changed! The order of the video parts in the recorded file is wrong.
5. If a new start point is set, however no-one new end point (00:00:00:000), the conversion is carried out up to the end of file. An error warning is missing (e.g. "Start point greater than end point!").
6. If a conversion has been carried out and only the start point is corrected after that (end point is still the previous), the conversion is carried out up to the end of file.
1. At the cut position artefacts are produced (as described by Ralle http://www.fame-ring.com/forum/viewtopi ... t=157#p685).
2. If conversion is stopped ("Exit" in window "Please wait for message: conversion done!"), the program crashes: Error message of Microsoft Virtual C++ Runtime Library.
3. If a file shall be overwritten ("Record List!" and "link" activated), a new file is produced. If e.g. the file to be overwritten is called "Test.ts", then the new file reads "test.ts.12.ts". If "Test.ts" shall be overwritten further times, then the new additional files read "Test.0.ts", "Test.1.ts", etc.. The file "Test.ts" is never overwritten.
4. If the order of the batch list is changed by drag and drop, only the lines are moved in the list on the screen. However, "view" shows that the order of the internal list hasn't changed! The order of the video parts in the recorded file is wrong.
5. If a new start point is set, however no-one new end point (00:00:00:000), the conversion is carried out up to the end of file. An error warning is missing (e.g. "Start point greater than end point!").
6. If a conversion has been carried out and only the start point is corrected after that (end point is still the previous), the conversion is carried out up to the end of file.