Search found 15 matches
- Fri Dec 03, 2010 9:16 pm
- Forum: Smart products - support
- Topic: No frame-accuracy trimming
- Replies: 6
- Views: 3910
Re: No frame-accuracy trimming
I think I have the same problem, and I do use v1.3.2. So my problem is that quite regularly, when I select a certain start point and end point, and add it to the list, the start point as it ends up in the list turns out to be a few frames earlier than what I had selected. So, when I'm done creating ...
- Fri Dec 03, 2010 9:12 pm
- Forum: Smart products - support
- Topic: Incorrect time-code?
- Replies: 5
- Views: 3671
Re: Incorrect time-code?
I have the same experience with v1.3.2 and the "TC 0 Base" option enabled. The start time of the first entry in the list becomes negative.vsf wrote:If 'TC 0 BASE' option is turned on,
then Result point interval displayed with negative values:
00-55:-7 - 00-52:-5
- Sat May 22, 2010 3:21 pm
- Forum: Features and Requests
- Topic: Smart Cutter: sound fading
- Replies: 4
- Views: 5744
Smart Cutter: sound fading
I think I have a real challenge for the programmer team: I would like to be able to tell for each start point and end point if the sound should be: - unmodified (as it is now) - fading in (at a starting point) or fading out (at an end point) - crossfading (should be specified both on an end point an...
- Sat May 22, 2010 3:00 pm
- Forum: Features and Requests
- Topic: Precision Point Sliders
- Replies: 5
- Views: 5968
Re: Precision Point Sliders
I think I understand rgracie's reasoning. I just started using Smart Cutter, and while I like very much the result of all my work, I didn't find it easy to get there. The idea of big and small slider is probably great for smaller videos, but not for longer ones. Because with the big slider I cannot ...
- Sat May 22, 2010 2:28 pm
- Forum: Features and Requests
- Topic: Drag-N-Drop
- Replies: 2
- Views: 3099
Re: Drag-N-Drop
In addition to dropping, also a filename on the command line would be very helpful, so that clicking on a move in Windows Explorer, and then right-clicking "Open with..." will work. Now if we do this, it opens Smart Cutter, but the movie itself is not opened (because Smart Cutter ignores t...